Connection In 2272563 Board Or Version 1 And 2 Of The 2272575 - Extraflame LCD Instrucciones Para El Uso

CONNECTION IN 2272563 BOARD OR VERSION 1 AND 2 OF THE 2272575

For the stove that installs the 2272563 board it is possible and recommended to install the adapter. The
adapter cable in fi gure 2 will be connected in the serial clamp in the board in fi gure 1.
1
From the clamp in fi gure 4 it is possible to start off the eventual cable (not supplied as per standard) in
order to reach the "conveyed waves" clamp already installed in the rear of the LCD console.
Nota bene: the clamp is polarised, therefore if the LCD does not switch on, invert the cables.
board 2272575 version 3
In the case of board 2272575 version 3 up, it is possible to connect the cable directly into the "conveyed waves" clamp, circled in
the photo. It is important to then select the correct connection via the display (see "CONNECTION" instructions).
CONNECTION IN 2272563 BOARD OR VERSION 1 AND 2 OF THE 2272575
2
code
002272585
3
4
connection
conveyed waves,
(clamp supplied as
per standard)
17