Signal Connections - Chauvet Professional COLORado Solo Batten 4 Guía De Referencia Rápida

AC Power
This product has an auto-ranging power supply that can work with an input voltage range of 100–240 VAC, 50/60 Hz.
Power Linking
You can link up to 14 COLORado Solo Batten 4 products at 120 V, 24 products at 208 V, or 26 products at 230 V. Never
exceed this number. Power linking cords can be purchased separately.
AC plug
Connection
AC Live
AC Neutral
AC Ground
• To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
• When using this product in an outdoor IP65-type environment, be sure to use IP65 (or higher) rated
power cables and secure unused ports with attached IP65 covers.

Signal Connections

You can link the COLORado Solo Batten 4 to a controller or controller software using a DMX connection or an Ethernet
connection. If using other Art-Net™ or sACN-compatible products with the COLORado Solo Batten 4, you can control
each individually on a single network. See the User Manual for information about how to connect and configure the
product for these signals.
Control Personalities
The COLORado Solo Batten 4 uses DMX, Art-Net™, and sACN for its 18 control personalities, ranging from 3-channel to
56-channel in 1-cell modes and 4-cell modes:
Mode
RGB
RGB EXT
RGBA
RGBA EXT
RGBAW
RGBAW EXT
RGBAW Fine
RGBAW FULL
HSIC
DMX Connection
The COLORado Solo Batten 4 will work with a DMX controller using a 5-pin DMX data connection. A DMX Primer is
available from www.chauvetprofessional.com.
Art-Net™ Connection
Art-Net™ is an Ethernet protocol that uses TCP/IP which transfers a large amount of DMX512 data using an Neutrik®
etherCON® RJ45 connection over a large network. An Art-Net™ protocol document is available from
www.chauvetprofessional.com. Chauvet Professional recommends using unicast Art-Net™ for best results.
Art-Net™ designed by and copyright Artistic Licence Holdings Ltd.
sACN Connection
Also known as ANSI E1.31, Streaming-ACN is an Ethernet protocol that uses the layering and formatting of Architecture
for Control Networks to transport DMX512 data over IP or any other ACN compatible network.
Master/Slave Connection
The COLORado Solo Batten 4 uses the DMX data connection for its Master/Slave mode. See the User Manual for
information about how to connect and configure the product for master/slave operation.
RDM (Remote Device Management)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally
along existing DMX cabling. Check the DMX controller's User Manual or with the manufacturer as not all DMX controllers
have this capability. The COLORado Solo Batten 4 supports RDM protocol that allows feedback to make changes to
menu map options. Download the User Manual from
COLORado Solo Batten 4 QRG Rev. 2
QUICK REFERENCE GUIDE
Wire (U.S.)
Black
White
Green/Yellow
1-Cell 4-Cell
3 12
8 27
4 16
9 31
5 20
10 35
10 40
16 56
9 29
Wire (Europe)
Brown
Blue
Green/Yellow
www.chauvetprofessional.com
Screw Color
Yellow/Brass
Silver
Green
for more details.
EN
2