Cosatto Moova 2 Manual De Montaje página 19

8 - installation of the car seat (forward facing) - 1
Place the child car seat on the vehicle seat. Incline the seat to position 3 (a) (See Step 3).
Push the vehicle seat belt through the gap in the seat as shown (b).
9 - installation of the car seat (forward facing) - 2
Fasten the vehicle seat belt (a). The straps should fit over the lower seat belt guide (b)
and below the lip above the lower seat belt guide (c).
Pull back on the diagonal belt to tension the waist belt (d).
10 - installation of the car seat (forward facing) - 3
Place the diagonal vehicle belt through the vehicle belt hook (a) and into the upper belt
guide (b).
Pull back on the diagonal belt to tension the vehicle seat belt (c).
Check the vehicle seat belt is not twisted.
Check the child car seat is securely fitted by lifting it slightly. Tighten the vehicle seat belt
if required.
IMPORTANT: The position of the seat belt/lap strap buckle can
affect the stability of the child car seat. In an accident this could stop
the child car seat from protecting your child
as well as it should. If, when the seat belt/lap strap belt is properly
tightened, the buckle lies in the position marked then try fitting
the child car seat in another seating position in your vehicle.
IMPORTANT: Each time you adjust the child car seat, check that it
is still secure, the back rest of the child car seat rests on the vehicles
seat and that the seat belt is tight. If there is any slack in the vehicle
seat belt then retighten it before starting your journey.
11 - removing the harness, seat liners and seat cover - 1
Remove the upper and lower seat liners.
Unfasten the harness straps and remove the shoulder straps and chest pads (See Step 6).
Unfasten the harness buckle. Remove the clips from the end of the harness straps (a).
Locate the crotch strap clip under the seat. Push the clip through the seat (b & c).
NOTE: The adjuster strap is not intended to be removable.
12 - removing the harness, seat liners and seat cover - 2
Starting on one side carefully pull the cover off from around the seat (a), the adjuster
button and strap (b).
Pull the cover off the harness straps (c).
Once the cover is removed feed the harness straps through the slots in the seat base (d & e).