Valore VS1205 Guía De Instalación Del Usuario página 18

NOTE: If the water outlet is below 33.38" on the template, the PVC cover is not required.
1. Peel off the paper backing to the adhesive ring
for the base plate cover.
2. Place the adhesive side to the wall and apply
pressure to secure the base plate cover.
(Note: Remove all residues to insure the cover
will bond properly)
3. Attach the elbow joint (part #3) to the brass
extender joint (part #4) and turn clock wise to
tighten.
4. Place the showerhead cover (part #2) to
conceal plumbing fixture.
• After all connections have been completed on
the rear of the shower panel, it is ready to be
hung unto the shower wall for permanent
installation.
• Simply raise the shower panel and bring close
to the surface of the shower wall and gently
lower it until the bracket support struts
pre-welded at the back of the shower panel
meet the Positioning & Support Brackets
installed in step 10. Please ensure the middle
part of the brackets (Part 14) are centered to
the middle part of the bracket support struts
which have a cut-out section to lock in the
brackets.
• Once a snug and secure fit is achieved and all
parts of the PVC Supply Line are secured to the
back of the shower panel, silicone sealant can
be applied to the rear of the shower panel
casing to hold it in place and prevent water
from entering the rear of the panel.
English
INSTALLATION
12
1
3
4
13
14
14
18
2
5
4
3
8
4
5
2
8