Air Bleeding - Beta 3067/70-13T Instrucciones

INSTRUCTIONS FOR USE
MAINTENANCE JOBS FOR THE END USER
- To ensure your jack a long life it is advisable to clean the pistons externally once a fortnight.
-
lowered. The oil level must be up to the small bolt that is on the side of the cylinder/tank, you can check by
loosening it. If you have to top up the oil in the tank make certain the oil you are using is compatible with what is
already inside the tank so as not to compromise machine integrity. DWG. 15
- If the oil level is higher than it should be, even by only a little, or if the jack has been turned up- side down (as
can easily happen during transport), the oil is expelled through the suction pump as mist. This phenomenon
disappears on Its own when the oil level hase been restored. If the oil inside the tank exceeds the level by a lot,
it is advisable to remove some until it is back in the norm.

AIR BLEEDING

advisable to bleed off all air.Fasi dello spurgo:
1. The piston must be moved out completely.
3. Start the lowering function until the piston moves back in properly.
4. Put the jack back into the working position.
5. Move the piston back in completely and check the oil level.
6.Try to operate the jack without any load and if the piston lowers in jerks repeat the procedure at least 2 or 3 times.
10
this must be done with the pistons completely
EN
DWG. 16