Tools And Materials; Before You Begin - Kohler K-18597 Guia De Instalacion

Tools and Materials

Level
Pencil
Measuring
Tape
Assorted
Screwdrivers
Drill

Before You Begin

IMPORTANT! The dimensions stated in this installation guide are
for a 36" (91.4 cm) vanity height, which is standard countertop
height. If an alternate height is desired, you must calculate your
own measurements for backing material height and bracket height.
Observe all local building codes.
Unpack the new product and inspect it for damage.
Assistance is recommended to successfully install the product.
If a lavatory/vessel will be installed, install the water supply and
drain lines before installing the vanity. Refer to the roughing-in
information included in the lavatory installation guide to properly
position the water supply and drain lines with the vanity
cutout/vessel location.
To properly support the vanity, 2x12 backing material must be
used in the finished wall.
Make sure the finished wall is straight and plumb, and the floor
is flat and perpendicular to the finished wall.
Select lag bolts according to your finished wall thickness and
rated with a minimum of 300 lbs (136.08 kg) load bearing.
It is recommended that the drawer be removed from the vanity
before beginning the vanity installation. Doing so will ease the
installation process. Refer to the "Remove/Adjust the Drawer"
section contained in this guide for proper removal.
1055673-2-C
Plus:
• Socket Wrenches with Sockets
• Lag Bolts 5/16" x 2-1/2"
• Flat Washers 5/16" ID
Safety
• Framing Nails
Glasses • Finishing Nails
• Bracket Screws
• Connection Screws 1-1/4"
• Flashlight
• Wood Shims
• C-Clamp and Soft Cloth
• 2x4 Lumber (optional)
2x12 Lumber
2 Kohler Co.