Taurus Prius 1400 Manual De Instrucciones página 17

Changing the dust bag:
- Change the dust bag when there is
a noticeable reduction in the suction
power of the appliance. (The dust bag
does not necessarily have to be full
to need changing; for example, if very
fine dust has been vacuumed this can
cover the pores in the bag and make
it necessary to replace it)
- In any case, change the bag when
the bag full indicator is completely
red.
- Disconnect the hose from the
vacuum cleaner's air intake.
- Open the bag compartment cover.
(Fig 4).
- Remove the bag from the bag sup-
port. (Fig 5).
- Check the condition of the motor
filter.
- Replace the bag with another one,
fitting it to the bag support.
- Close the bag compartment cover;
making sure it is shut properly.
- Connect the hose to the vacuum
cleaner's air intake.
Changing the filters:
Motor filter: Replacement is recom-
mended at least once a year or every
100 hours of use.
- HEPA air vent filter (High efficiency
air filter that efficiently retains spores,
ash, sawdust, pollen...), it is advis-
able to change it a least once a year
or after every 100 hours of use.
- To remove filters:
Motor filter:
- Open the lid of the bag compart-
ment and remove the bag. (Fig 4).
- The filter motor can be found in the
motor's turbine air entrance.
Manual Prius1400.indb 17
- Remove the part that keeps the filter
in place. (Fig 6)
- To replace the filter, follow the
instructions of the last section in
reverse.
Air exit filter:
- Open the air outlet grate to access
the filter. (Fig 7)
- Remove the filter from its housing.
- Change the filter.
- To replace the filter, follow the
instructions of the last section in
reverse.
Accessories
- Accessories (such as filters, etc.)
can be purchased from distributors
and authorised establishments.
- Supplies can be purchased in spe-
cialised shops.
Anomalies and repair
- Take the appliance to an authorised
technical support service if problems
arise. Do not try to dismantle or repair
without assistance, as this may be
dangerous.
- If the connection to the mains has
been damaged, it must be replaced
and you should proceed as you would
in the case of damage.
For EU product versions and/or in
case that it is requested in your
country:
17
09/08/10 9:55