Spyker Spreaders ROS 5 S100-12011 Manual Del Operador página 12

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance
WARNING: AVOID INJURY! DISCONNECT THE SPARK PLUG WIRE TO PREVENT THE ENGINE
FROM ACCIDENTALLY STARTING BEFORE PERFORMING ANY MAINTENANCE ON THIS MACHINE.
G. CHANGING THE PUMP DRIVE BELT:
1. Remove fan guard.
2. Remove skid plate.
Fig. G-2
Skid Plate
(Lightly
Shaded)
Skid Plate Hardware
1017459 Rev. C
Fig. G-1
Fan
Guard
Skid Plate Hardware
12
3. Remove the two (2) screws and nuts from the tensioner
bracket.
Remove these
Tensioner
Bracket
4.
Unhook spring from idler pully bracket.
5. Unhook idler pulley from the belt.
Idler Pulley
Bracket
Spring
6.
Unhook belt from engine pulley.
7.
Pull belt through the top of the sulky, where the fan
guard was removed.
8.
Install new belt through the top of sulky and around
transaxle pulley. Hook belt to engine pulley.
9.
Hook belt to idler pulley. See figure G-4.
10. Hook spring to idler pulley bracket.
11. Resecure the two (2) screws and nuts from the idler
pulley support bracket. See figure G-3.
12. Reattach the skid plate. See figure G-2.
13. Reattach the fan guard. See figure G-1.
©2016 Spyker Spreaders/A Brinly-Hardy Co.
Fig. G-3
Fig. G-4
Belt

Publicidad

Capítulos

Tabla de contenido
loading

Productos relacionados para Spyker Spreaders ROS 5 S100-12011

Este manual también es adecuado para:

S100-12011

Tabla de contenido