Operating Instructions; Engine On/Off Switch - Spyker Spreaders ROS 5 S100-12011 Manual Del Operador

Assembly Instructions
WARNING: AVOID INJURY!
WEAR SAFETY GLASSES, STURDY
GLOVES & APPROPRIATE FOOTWEAR.
Fig. 3
5/16"
Nylon Lock Nuts
IMPORTANT:
Make sure the cables are not kinked and do
not get pinched before assembly.
7. Check the engine oil level and the function of all
controls per instructions in the OPERATING
INSTRUCTIONS section (pages 8-10) and the
MAINTENANCE section (pages 11-12).
8. Calibrate spreader according to instructions in
SPREADER SETTINGS Section (pages 13-14).
©2016 Spyker Spreaders/A Brinly-Hardy Co.

Operating Instructions

5/16"-18 x 1"
Flange Head
Bolts
A. CONTROLS

1. ENGINE ON/OFF SWITCH:

The ON/OFF switch is located on the far left side of
the control panel. To start the engine, set the switch
to the "ON" Position. To turn off, throttle down the
engine, then set the switch to the "OFF" Position.
2. FUEL SHUTOFF VALVE:
The fuel shutoff valve is located between the
carburetor and the fuel tank on the LH side of the
engine. The handle turns 90 degrees to open or
close. When the handle is in the horizontal position,
it will open the flow of fuel to the engine. When it is
turned to a vertical position, it will shut off the fuel
flow to the engine. Anytime the spreader is being
trailered, or if the machine will not be in use for 30
minutes or more, close the fuel shutoff valve to
prevent flooding the engine.
7
Engine
ON/OFF Hopper Side
Switch Shut-Off Deflector
HOPPER
SHUT-OFF
CAUTION
OPEN
Serious bodily injury may
result from failure to follow
safe operator procedure.
• Read the operator's manual before
operating this machine.
• Clear area of debris.
• Do not remove or disable shields, guards,
or safety devices.
• Always chock the wheel or engage the
parking brake when transporting the
machine or when parking on a grade.
• Stop engine, disconnect spark plug, set
parking brake before adjusting or servicing.
• Keep people and pets a safe distance away
from machine.
• Do not add fuel while engine is warm or
running.
• Use caution on slopes.
• Before leaving the operator's position, wait
for all movement to stop.
• Do not allow operation of the machine by
untrained personel.
FOR FIRST-TIME OPERATORS
CLOSED
• START OFF IN A FLAT, OPEN AREA.
• KEEP BYSTANDERS AWAY
• SET THROTTLE AT A LOW SPEED.
• PRACTICE MANEUVERING,
(FORWARD, REVERSE, LEFT, RIGHT)
Reverse Speed
Ground Control Lever
Speed (Application
Control Transport)
Accuway
Spread
Calibration
SIDE ACCUWAY ®
DEFLECTOR SPREAD CALIBRATION
DOWN OFF
OFF
UP
Fig. 4
Forward
Ground Speed
Control
1017459 Rev. C