RCA ANT800 Guia Del Usuario página 5

Mounting to a Mast
U-Bolt
Wing Nut
1. Orient the antenna base.
Make sure the base is oriented correctly for
the direction you want to point the antenna.
Use the illustration on the left as a guide.
Mounting
Well
2. Attach the clamp assemblies to the base.
Find the two U-Bolts, the four wing nuts,
and the two clamps included in this
package.
Insert each U-Bolt into the base as shown
here. Then position a clamp and two wing
nuts on the end of each of U-Bolt as shown
Clamp
here.
3. Mount the base to the mast (not included).
Slide the antenna clamp assembly over the
mast as shown here, positioning the mast
between the clamp and the antenna.
Position the ANT800 antenna as high as
possible on the mast. Orient the base in the
direction you want. Then tighten the clamps
and wing nuts securely onto the mast.
4. Attach the arm to the base.
Find one of the screws, washers, and nuts
included in the package.
First, set the washer and nut in the
mounting well. Then position the arm over
the other side of the well. Attach the arm to
the base as shown here.
Screw Cover
continues on next page...
5