Amplifier Visual Troubleshooting - Directed Electronics ORION XTR2504 Manual Del Propietário

slight distortion and turn the level control back slightly for an
undistorted output . Depending on your system, the midrange and
tweeter output may be on the same output channels .
6 . turn up the level control corresponding to the tweeter output
until you hear slight distortion and turn back the level control
slightly for an undistorted output . Depending on your system
the midrange and tweeter output may be on the same output
channels .
7 . Fine-tune the output level between midrange and tweeters .
Refer to the Internal Crossover Configuration section of this
manual for detailed instructions .
8 . Repeat steps 5-7 for the rear speakers . If you do not have rear
speakers continue to step 10 .
9 . set levels between the front and rear midrange and tweeters for
optimum front/rear balance .
10 . turn up the level control corresponding to the woofer output
until you hear slight distortion and turn back the level control
slightly for an undistorted output .
11 . Fine-tune the output level between satellite speakers and the
woofers . Refer to the Internal Crossover Configuration section of
this manual for detailed instructions .
12 . enjoy your awesome orion sound system .
© 2008 Directed Electronics. All rights reserved.

Amplifier Visual Troubleshooting

Your new XtR amplifier has three indicator lights (LeD's) mounted on
the top plate of the amplifier as seen in the next figure . these lights
are very useful in trouble shooting possible amplifier problems and
issues .
Power LED: this LeD lights up green when the amplifier is turned on .
this represents normal operation if the Protection and thermal LeD's
next to it are off .
Protection LED: this LeD lights up red if the amplifier goes into
protection . Below is a description of reasons the amplifier could
engage the protection circuit . the protection indications will self
reset once the condition has been fixed .
• Short: speaker wires pinched or shorted together or to ground
(frame of vehicle) .
• Overcurrent: Check for possible speaker issue(s) or speaker wiring
pinched in a door or other metal . Make sure speaker(s) load is
not below the minimum impedance load .
• DC Offset: this can happen if the installation inadvertently
connects the power wire to the speaker input(s) . this can also
happen if the amplifier has an internal problem .
• Undervoltage: Vehicle charging system is not supplying enough
voltage to the amplifier . this can also occur if you use too small
a gauge wire or the terminals connecting the amplifier power to
the electrical system are dirty or corroded .
• Overvoltage: Vehicle charging system is supplying too much
voltage or over the amplifiers rated DC input . Usually this occurs
when there is a problem with the electrical system . turn off the
headunit when jump-starting the car .
16