Plumbline 3000 Serie Manual Del Propietario E Instrucciones De Instalación página 18

System Setup (continued)
11
Set time of day.
• Set time of day by holding the Up or Down arrow.
• Hold the Extra Cycle button until the Program icon
disappears to save the current time.
12
Set regeneration detail.
• Press the Mode button to advance to Time of Regen.
Push the Up or Down arrow to select the time of
day you would like your system to regenerate
(typically late at night when no one is using water).
• Press the Mode button again to advance to Salt Amount.
Press the Up or Down arrow to select your salt dosage
using the chart on the next page. Salt dosages range
between 3 and 18 lbs. per cubic foot of resin.
• Press the Mode button again to advance to Hardness.
Press the Up or Down arrow to adjust the setting to the
untreated water hardness. Hardness range is 3-200 gpg.
• Hold the Extra Cycle button until the program icon
disappears to save your programming.
• Press the Mode button again to advance to Capacity
Remaining. This is the amount of gallons the unit can
treat. This is not adjustable.
• If you are just changing one program step, hold the
Extra Cycle button until the program icon disappears
to save your changes. If you do not hold the Extra
Cycle button until the program icon disappears, your
changes will not be saved.
NOTE: This unit has a day of the week reserve. It
calculates a reserve for each day of the week based
on water usage over the past four weeks.
17