Snapper SZ2246 Manual Del Operador página 16

Tabla de contenido

Publicidad

OPERATION
Safety section and following pages, if
Training
riding mowers.
prior to attempting to move the mower under its
until becoming comfortable with controls, use
a reduced throttle speed and reduced ground
furthest forward or reverse positions during initial
operation.
First time users must become familiar with the
mower's movement on a hard surface, such
to operate on turf. Until the operator becomes
comfortable with the mower controls and zero
Steering
To move forward and backward
control lever controls the right wheel.
Moving
Machine By Hand in the Operation section) to
its own power, the operator must sit in the seat
and start the engine (see Before Starting in the
Operation section). Adjust the engine speed to
inward. As long as the control levers have not
will not move.
neutral position and the mower will stop moving.
levers forward to the neutral position and mower
will stop moving.
16
To turn to the right
While moving in a forward direction, pull the right
maintaining the position of the left lever, this will
slow the rotation of the right wheel and cause the
machine to turn in that direction.
To turn to the left
While moving in a forward direction pull the left
maintaining the position of the right lever, this will
slow the rotation of the left wheel and cause the
machine to turn in that direction.
To zero turn
forward position and the other in the reverse
position, complete the turn.
WARNING
free of stones and other objects that could be
Before Starting
1.
Safety and Controls
before starting the machine.
2.
starting (see Maintenance Schedule in the
Maintenance section).
3.
4. Adjust the seat to the desired position.
5.
pin into the desired cut height.
MANTENIMIENTO
arrancar el motor sin cumplir una de las
vuelva a intentarlo.
sistema de seguridad antes de volver a usarla.
operador abandone el asiento.
abandona temporalmente el asiento.
INFORMACIÓN IMPORTANTE Para poder
conducir, el operador debe sentarse en el
Freno de estacionamiento
acción de frenado. Para ajustar el freno de
estacionamiento, póngase en contacto con el
taller de servicio de Snapper.
accidente.
Presión de los neumáticos
INFORMACIÓN IMPORTANTE NO agregue
rellenos de espuma causan fallas prematuras.
fabricante original.
Discos de corte
debe realizarlo un taller de servicio
autorizado.
Para conseguir el mejor efecto de corte, es
cuchilla con mellas grandes se puede reparar o
cuchillas.
Reemplazo de las cuchillas
1.
2.
UP (este lado hacia arriba) orientado hacia el
3.
cuchilla.
4.
(122 Nm).
INFORMACIÓN IMPORTANTE
Ruedecillas
Para volver a
instalar, siga el orden inverso. Apriete el perno
lb (61 Nm).
57

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

96794770100

Tabla de contenido