Safety Instructions - JB Systems u-Quantum Laser Manual De Instrucciones

ENGLISH

SAFETY INSTRUCTIONS:

The lightning flash with arrowhead symbol within the equilateral triangle is
intended to alert the use or the presence of un-insulated "dangerous voltage"
within the product's enclosure that may be of sufficient magnitude to constitute a
risk of electric shock.
The exclamation point within the equilateral triangle is intended to alert the user
to the presence of important operation and maintenance (servicing) instructions
in the literature accompanying this appliance.
This symbol means: indoor use only
This symbol means: Read instructions
This symbol determines: the minimum distance from lighted objects. The
minimum distance between light-output and the illuminated surface must be
more than 1 meter
The device is not suitable for direct mounting on normally flammable surfaces.
(suitable only for mounting on non-combustible surfaces)

To protect the environment, please try to recycle the packing material as much as
possible.

A new light effect sometimes causes some unwanted smoke and/or smell. This is normal
and disappears after some minutes.

To prevent fire or shock hazard, do not expose this appliance to rain or moisture.

To avoid condensation to be formed inside, allow the unit to adapt to the surrounding
temperatures when bringing it into a warm room after transport. Condense sometimes
prevents the unit from working at full performance or may even cause damages.

This unit is for indoor use only.
Don't place metal objects or spill liquid inside the unit. Electric shock or malfunction may

result. If a foreign object enters the unit, immediately disconnect the mains power.

Locate the fixture in a well ventilated spot, away from any flammable materials and/or
liquids. The fixture must be fixed at least 50cm from surrounding walls.
Don't cover any ventilation openings as this may result in overheating.


Prevent use in dusty environments and clean the unit regularly.

Keep the unit away from children.

Inexperienced persons should not operate this device.
The safe ambient temperature is between 15° & 40°C. Don't use this unit at higher

ambient temperatures.

Make sure the area below the installation place is free from unwanted persons during
rigging, de-rigging and servicing.

Always unplug the unit when it is not used for a longer time or before replacing the bulb
or start servicing.

The electrical installation should be carried out by qualified personal only, according to
the regulations for electrical and mechanical safety in your country.

Check that the available voltage is not higher than the one stated on the rear panel of the
unit.
JB SYSTEMS
®
CAUTION: To reduce the risk of electric shock, do not
remove the top cover. No user-serviceable parts
inside. Refer servicing to qualified service personnel
only.
2/36
USER MANUAL
µ-LASER