Publicidad
Idiomas disponibles
Idiomas disponibles
Accessory Body Wire Harness Installation - Driver's Side
Door Sill Plate Routing:
31. Route body harness jumper underneath driver's side door sill
plate along side existing sill plate wiring harness, making
sure it's tucked into trench and away from sill plate clips -
see Figure 31.
FIGURE 31
32. Continue routing body harness jumper forward in vehicle
underneath and behind body hinge pillar trim panel, forward to
body wire harness junction block, wire tie to existing wiring
(trim excess length) - refer to Service Procedure 1674293 -
see Figure 31.5.
FIGURE 31.5
Accessory Body Wire Harness Installation - Body Wire
Harness Junction Block:
33. Remove junction block cover - see Figures 32 and 33.
FIGURE 32
NOTE: Steps 34-43 are for Pick-up trucks ONLY. For SUV and
Avalanche, skip to Step 44.
Heated Seats
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
FIGURE 33
REVISION
AUTH
34. Remove junction block from bracket - refer to Service Proce-
dure 1712282.
35. Remove all four connectors from bottom side of junction block
- see Figure 34.
NOTE: It may be necessary to pry connector (carefully)
out of junction block with screw driver after lever-lock is
swung open.
36. Remove lever-lock and then the terminal position assurance
(TPA) plastic piece from the 56-way connector by prying-out
with terminal pick - see Figure 35.
NOTE: This step and the following procedure applies to
both 56-way connectors, but only do one at a time.
37. Remove terminal from cavity 'M3' with terminal pick - see
Figures 36 and 37.
FIGURE 36
PART NO.
REV 13MR08
INSTALLATION INSTRUCTIONS
DR
TITLE
PART NO.
19159289
6200 Grand Pointe Dr., Grand Blanc, MI 48439
FIGURE 34
FIGURE 35
FIGURE 37
19159289
SHEET
Heated Seats
5
SHEET
5
24
OF
24
OF
Publicidad
