B.O.B REVOLUTION FLEX DUALLIE Guia Del Usuario página 8

BOB Gear
Rear Wheel Removal
1� Unlock Parking Brake
Prior to removing the rear wheels,
position the parking brake in the
unlocked position.
2� Remove Wheel
Raise the wheel a few inches off
the ground, pull the release lever,
and pull the wheel out of the rear
wheel attachment bracket.
Front Wheel Installation
1� Remove Through-Axle and Hex
Wrench From Storage Bag
Remove nut from through-axle.
Through-
Nut
Axle
6
2� Rotate Front Fork Into Jog
Mode
Rotate the front fork until it locks
into jog mode. See page 9.
3� Insert Front Wheel
When facing the front of the
stroller, insert the wheel between
the fork and align the wheel hub
with the holes in the fork blades.
4� Insert Through-Axle
Insert the through-axle into the
fork and through the wheel hub,
then install the nut to the opposite
side.
5� Tighten Through-Axle
Hold the nut in place, and use
the hex wrench provided to fully
tighten the through-axle. Pull on
wheel to check that it is securely
installed and does not wobble.
Hex
Wrench
Nut