Assembly And Detachment Of Components According To Model - ZUMEX Speed Pro Manual De Usuario

Assembly and detachment of
components according to model
Right cover side outlet (2), Left cover side outlet (3), Left cover side outlet S
The side outlets are not the same. Ensure that the correct side outlet is installed on the
corresponding side.
Assembly of the outlets (Fig. 10).
Line up the bottom of the side outlet and lift up the upper part, ensuring that it closes with
a 90º turn of the knob.
Mount the right outlet by turning the latch clockwise.
Mount the left outlet by turning the latch counter-clockwise.
! Important! There are icons on the part indicating the direction of the turn, do not force
the tab in the opposite direction.
Ensure that the side outlets are fully installed and correctly positioned in their place.
Disassembly of the outlets (Fig. 10)
Remove the right outlet by turning the latch counter-clockwise to its vertical position.
Remove the left outlet by turning the latch clockwise to its vertical position.
Cover (1)
Assembly of the cover (Fig. 10.1)
Check that the knobs on the shafts of the machine are turned perpendicular to the floor (open)
Hold the cover by the outlet holes, match the holes with the knobs and press until they are
completely inserted. Turn the knobs 90º degrees clockwise to secure the cover.
! Important! Avoid forcing the cover onto the machine if the shafts are not completely
aligned, as this may damage the part.
Disassembly of the cover (Fig. 10.1)
Turn the knobs 90º degrees until they align with the holes in the cover.
Remove the cover with a horizontal movement, holding it with both hands by the outlet holes.
! Important! Avoid forcefully removing the cover if the shafts are not completely aligned, as
this may damage the part.
Lower pressing unit (4), Upper pressing unit (5)
Place the pressing units in the shafts (Fig. 1).
If you have a Speed S +plus then refer to the section 1Step kit (19+). Always mount the lower and
upper pressing units of the same side at the same time to make it easier to position them.
(3+)
+plus
Injection Plastic Securing Knob (6)
Screw in the knobs to secure the pressing units and the feeder plate (Fig. 1).
If you have a Speed S +plus then refer to the section 1Step kit (19+).
Left peel ejector (7), Right peel ejector (8)
Assembly of the ejector (Fig. 21).
Place the ejectors on the corresponding side and insert them onto the knobs. Push the ejector
until the blade is fully inserted into the lower pressing unit and the channel makes contact
with the second knob.
Important! If the ejector is not correctly installed as indicated above, the part may be
!
damaged when the machine is in operation.
If you have purchased the Speed S +plus model, read the 1Step Kit (19+) section.
Disassembly of the ejector (Fig. 21)
Pull the ejector out until it is completely free from the machine.
Important! Remove the ejectors before removing other parts of the juicing unit.
!
Blade holder (9)
Place the blade carefully on its guide and push inwards (Fig. 1).
Blade holder S
Place the blade carefully on its guide and push inwards (Fig. 1+).
Note: Always insert before inserting the 1Step kit.
(9+)
+plus
EN
47