Hardware Included; Installation; Suspension Mounting - Commercial Electric 50232161 Guía De Uso Y Cuidado

Pre-installation (continued)

HARDWARE INCLUDED

nOTe: Hardware not shown to actual size.
Part Description
AA Cover Plate
BB Cable Set
CC Chain with S-Hook
DD Electrical Box Screw
EE Wire Connector
FF Power Tool Hex Bit

installation

WarninG: RISK oF ELECTRIC SHoCK. Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off the
circuit breaker before removing the existing light fixture or installing the new one.
With power disconnected to the electrical box, remove the existing fixture. Make a sketch of how the current fixture is wired (by wire color)
or mark the wires with masking tape and a pencil so you will know how to properly reconnect the wires to the new LED light fixture.

suspension Mounting

1
Removing the power supply box
□ Remove the four screws that attach the power supply box to the LED fixture body (A) using the power tool hex bit (FF).
□ Put the screws aside as they will be needed to reattach the power supply box to the fixture body (A) in a later step.
□ Lift the power supply box from the fixture body (A) and unplug the Quick Connect wires.
Power Supply Box
Quantity
1
2
2
2
3
1
FF
AA
EE
Power Supply Box
A
4
CC
BB
FF
A
DD
Quick
Connect