Commercial Electric 50232161 Guía De Uso Y Cuidado página 5

suspension Mounting (continued)
2
Preparing the power supply box for wiring
□ Remove the knock-out near the end of the power supply box.
□ Fit a 1/2 inch snap-in bushing into the knock-out hole.
□ Feed the wiring out through the bushing and knock-out hole.
□ Reconnect the two ends of the Quick Connect wires.
□ Align the screw holes in the fixture body (A) with the screw holes
in the power supply box.
□ Fasten the fixture body (A) to the power supply
box with the previously removed screws, using the
power tool hex bit (FF).
Power Supply Box
3
Mounting to drywall
□ Drill two holes large enough to clear the closed flaps of the
butterfly nut on the toggle bolt (not included).
□ Fasten the toggle bolt into the butterfly nut before
inserting the flaps into the ceiling.
□ Tighten the toggle bolt.
Quick
Connect
A
Power Supply Box
Power Supply Box
FF
4
Mounting to wood
□ Drill two 1/16 in. diameter holes in the ceiling to
accommodate hook screws (not included).
□ Fasten the combo wood-machine end into the metal hook.
□ Tighten the hook screw (not included) into the wood.
5
Please contact 1-877-527-0313 for further assistance.
Knock-out Hole
A
HoMEDEPoT.CoM