Replacing The Belt - Bissell PROHEAT ADVANCED 1846 Serie Guia Del Usuario

Replacing the Belt

1
Brush Belt
Insert a flathead screwdriver to
remove the Belt Access Door.
(There is a slot at the end of the door.)
Pull the Belt Access Door up and out.
3
Pump Belt
If the pump belt is
broken install a new
one by looping the
new belt around the
red pump pulley and
then stretch it to the
silver motor shaft.
2
Turn the machine to
lay on its side so the
belt access area is
facing upward. Use a
Phillips-head screwdriver
to remove the screws
on the arms that hold
the brush in place. If the
brush belt is broken,
gently remove the
belt. To reinstall a new
belt, first place the belt
around the pulley and
then stretch it to wrap
around the brush gear.
4 To return the Belt Access Door,
line it up with the slots in the
machine. The door will slide into
place and snap shut.
www.BISSELL.com
13