Publicidad
Step 6
Fasten six ANGLE BRACKETS (OO) to the HUTCH ENDS (C and D).
å
Use six GOLD 9/16" LARGE HEAD SCREWS (III).
NOTE: The ANGLE BRACKETS should not be even with the edges of
å
the HUTCH ENDS. The HUTCH MOLDINGS will rest on the edges of
the HUTCH ENDS.
Fasten the HUTCH MOLDINGS (BB) to the HUTCH ENDS (C and D).
å
Use six GOLD 9/16" LARGE HEAD SCREWS (III) through the ANGLE
BRACKETS and into the HUTCH MOLDINGS.
NOTE: There are no pre-drilled holes in the MOLDINGS (BB). The
å
SCREWS will tighten into the grooves.
(6 used)
OO
BB
www.sauder.com/services
OO
BB
C
D
These edges
should be even.
401354
GOLD 9/16" LARGE HEAD SCREW
(12 used in this step)
These edges
should be even.
III
Page 11
Publicidad
