Publicidad
Step 18
Unfold the BACKS (N and O) and lay them over your unit. The
å
notches in the DESK BACK (N) should fi t into the notches in the
HUTCH BACK (O).
Make equal margins along all four edges of the BACKS (N and O).
å
Push on opposite corners of your unit if needed to make it "square".
Fasten the BACKS (N and O) to your unit using the NAILS (MMM).
å
NOTE: Be sure to tap NAILS into the holes that line up over the
å
UPRIGHTS (E and G) and SHELVES (K and L).
NOTE: Perforations have been provided for access through the
å
BACK. Carefully cut out the holes needed. Carefully cut out the
rectangles in the BACKS for proper ventilation of your CPU.
www.sauder.com/services
These holes must line up
over the UPRIGHTS (E and G)
and SHELVES (K and L).
Notch
O
N
401354
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(72 used in this step)
MMM
Page 23
Publicidad
