Display Of Operating Data And Counters - Climit 24 HE Plus Manual De Instalación Y Mantenimiento

– as a precautionary measure, close the gas isolation valve.
Repair the fault and start-up the boiler again.
after having repaired the fault, when the alarm number
NOTE:
appears on the display together with the message
(see figure), press the button
to start the appliance up again.
3.5

Display of operating data and counters

Once the boiler is operating a qualified technician can view the
operating data and the counters as follows:
– from the operating screen in the mode enabled at that
moment (WINTER n
– go into "DISPLAY" by pressing the buttons
for more than 3 seconds until the following screen
same time
appears
From this point, the technician has 2 options:
– scroll through the list of "information (PAR)" and "counters
by pressing the button
(PARc)"
122
y for approximately 3 seconds
or SUMMER l )
r and
t . Scrolling will be in sequence
– display the "activated alarms" (no more than 10) by pressing
the button r
d
– Once in this section, proceed with button
When all the values have been displayed, exit the menu by
pressing and holding down the button
seconds until the initial screen is displayed.
TABLE OF INFORMATION DISPLAYED
Type No.
PAR 00
PAR 01
PAR 02
PAR 03
< at the
PAR 04
PAR 05
PAR 06
PAR 07
PAR 08
PAR 09
PAR 10
t
y for approximately 5
Description Range
SW version
- 9 ..
External sensor
99
Delivery sensor - 9 ..
temperature 99
- 9 ..
Smoke probe
99
Domestic hot water - 9 ..
sensor temperature 99
- 9 ..
AUX auxiliary sensor
99
Par.
Actual heating SET 13 ...
temperature Par.
14
0 ..
Power level
99
0 ..
Flow meter rate l/min
99
Water pressure 0 ..
transducer reading 99
Display of current 0 ..
RPM x 100
fan revolutions 99
EN
or r .
U/M Step
°C 1
°C 1
°C 1
°C 1
°C 1
°C 1
% 1
0.1
bar 0.1
1