Q Acoustics 2000i Serie Manual De Usuario página 13

Connecting the 2070Si
Multi-Channel AV System
Connections
Standard Connection is via the Line level RCA phono Inputs. For a typical
AV system set-up you will need a single RCA phono interconnect. As this
cable is likely to be quite long, make sure you get a good quality fully
screened cable. Your Q Acoustics dealer will be happy to supply you with
a suitable interconnect.
AV AMPLIFIER
RIGHT LEFT
REAR LS
CENTRE LS
Connect the SUBWOOFER OUTPUT on the AV amplifier to the L/Mono
Line input on the subwoofer, pushing the plugs firmly home to ensure a
good contact.
Setting Up
Check that all system connections are properly and securely made.
Ensure that the subwoofer is switched off.
SUBWOOFER
RIGHT LEFT
IN
SUB
LEFT /
OUT
MONO
FRONT LS
IN
RIGHT
Set the controls to the following default settings:
Level
Crossover
Phase
Sound Mode
Phase invert
Auto on sensitivity
LINE
Speaker type
Plug the supplied power cord into the subwoofer and then into the AC
supply socket. Switch on the power at the supply socket and then switch
the power switch on the subwoofer to 'ON'. The POWER light on the
subwoofer amplifier panel will glow and the subwoofer is operational.
Check the settings on your AV amplifier to make sure that the sub-woofer
is set to 'ON 'or YES. The sub-woofer level on the AV amplifier should be
set at its default position or 0dB. You should already have set the speaker
sizes and positions for all the other speakers in your system. If you have
the option to set the crossover frequency on the other channels make
sure this is set appropriately to your speakers. Set the distance (or delay)
setting that is correct for the sub-woofer position you have chosen.
Approximately half
Fully clockwise (AV setting)
Fully anti-clockwise (0° setting)
AV
0°
Med
No effect when crossover set to AV so
either position