Q Acoustics 2000i Serie Manual De Usuario página 7

Preparation
Fitting the Floorstand Spikes - 2050i
Thread the spikes fitted with locking
nuts half way into the base and return
the loudspeaker to the upright
position. (If you have a wood or stone
floor push a spike protector over each
spike before turning the speaker
upright) When the speaker is the right
way up, insert the Allen key into each
spike from the top and adjust all the
s p i k e s i n a n d o u t u n t i l t h e
loudspeaker is level and stable.
Spikes are sharp. Exercise care!
Never place a spiked loudspeaker where it can cause damage!
Always move your loudspeakers by lifting them - never drag them!
Foam Bung
The 2000i series speakers are rear ported and designed to work best with
some space behind them i.e. 200mm or so away from a wall. If you
position your speakers close to a wall/ corner then the foam bungs
should be inserted into the rear ports or there could be too much bass.
The 2070Si subwoofer bass is adjusted using the level controls.
Ensure the bungs are fitted snugly into the port without inserting them too
far. You will find the level of bass is reduced but definition and bass
extension is increased. Experiment to see what you prefer and try making
small changes to the position of the speaker to optimise the final result.