KREA Swiss volumeSPRAY Manual De Instrucciones página 6

The sprayer is designed with quality components. If you experience any issue, we
recommend first following the trouble shooting document and film available on our
website: www.kreaswiss.com. In most cases a part has been forgotten or the product
needs a thorough cleaning. If your issue persists, please contact your reseller for
additional support. Please always include the article number (page 13) in any
correspondence.
DISMANTLING AND ASSEMBLING (see page 13-14)
 Remove the round jet nozzle (9) and then unscrew the bent nozzle extension screw
(8) from the pump housing (5).
 Remove the atomiser insert (7) and valve ball (6) from inside the chamber. Place
all parts in a small dish and clean them following the cleaning steps outlined earlier.
The suction tube (10) and container (11) can be washed in the sink.
 Remove the service screw (2) and take off the pump housing (5). Put the piston
(3), piston spring (4), hood (1) to one side and wipe them down as outlined above.
 Remove the valve ball (6) from the pump housing (5) by using a copper or brass
pin to push it through the piston aperture.
 To assemble the gun, do so in reverse order. The piston should move freely in the
pump housing. Ensure the service screw, nozzle extension and round jet nozzle
pieces are all screwed on tightly.
6