Technical Features; Equipment Description; Installation And Starting Up - J.P. SELECTA LABOR-LAM Manual De Instrucciones

MANUAL DE INSTRUCCIONES
Screen useful
measures cm
Code
Height Length
3000438 8.5 30
¡ATENCIÓN! IMPORTANTE PARA SU SEGURIDAD
CAUTION!!! IMPORTANT FOR YOUR SAFETY
J
.P. SELECTA s.a.u.
CODIGO 80103 REV E Octubre 2019

TECHNICAL FEATURES

Voltage supply 115-230V 50/60 Hz.
Overall dimensions cm
Height Length
32 13

EQUIPMENT DESCRIPTION

LABOR-LAM lamps are recommended for film examinations,
transparencies, graphs, analysis, etc.
Equipped with a clip stand for transparencies, plastic screen with
rounded edges to avoid scratches.

INSTALLATION AND STARTING UP

* Installation in vertical position:
- Fix the lamp onto the holes at the back of the casing.
- Connect the plug into the mains.
- Press the switch to start the lamp.
* Installation in tabletop position:
- Assemble the screws of the hinge as in Fig. 1.
- Assemble the wing nuts as in Fig. 1.
- Connect the plug into the mains.
- Press the switch to start the lamp.
Be sure that the voltage supply is the same as the one indicated
on the characteristic plate of the equipment.
Do not use the equipment if it is NOT earthed.
If you have to change the plug, bear in mind the following:
Blue cable:
Brown cable:
Yellow/green cable:
Autovía A2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - http://www.grupo-selecta.com
(Sujetas a modificaciones sin previo aviso)
Sreen
Max.
max.
inclination
temp.
Width
5.5 35ºC 45ºC
Neutral.
Phase.
Earth.
LED lamp
12V 6000K
Tel (34 3) 770 08 77 Fax (34 3) 770 23 62
Pag.: 6
Weight
Kg.
1.4