Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION AND SERVICE INSTRUCTIONS FOR MODEL AM100T DRIVER
SAFETY MESSAGE TO INSTALLERS, USERS AND MAINTENANCE PERSONNEL
It is important to follow all instructions shipped with this product. This device is
to be installed by a trained electrician who is thoroughly familiar with the National
Electrical Code and will follow NEC Guidelines as well as local codes.
The selection of the mounting location for the device, its controls and the routing
of the wiring is to be accomplished under the direction of the facilities engineer and the
safety engineer. In addition, listed below are some other important safety instructions
and precautions you should follow:
•
This is not a Listed safety device and is not intended to be used as such.
•
Read and understand all instructions before installing or operating this
equipment.
•
Do not connect this unit to the system while the power is on.
•
All effective warning speakers produce loud sounds which may cause in
certain situations, permanent hearing loss. You should take appropriate
precautions such as wearing hearing protection.
•
All effective warning speakers produce loud sounds, which may cause, in
certain situations, permanent hearing loss. The device should be
installed far enough away from potential listeners to limit their exposure
while still maintaining its effectiveness. The OSHA Code of Federal
Regulations 1910.95 Noise Standard provides guidelines which may be
used regarding permissible noise exposure levels.
•
After installation, test the sound system to ensure proper operation.
•
After testing is complete, provide a copy of this instruction sheet to all
operating personnel.
•
Establish a procedure to routinely check the speaker installation for
integrity and proper operation. Any maintenance must be performed by
a trained electrician in accordance with NEC guidelines and local codes.
Failure to follow all safety precautions and instructions may result in property
damage, serious injury, or death to you or others.
A.
DESCRIPTION.
The Federal Signal Model AM100T is a heavy-duty, transformer coupled, 100-watt,
compression driver for use in high-power public address installations. Power handling
for the AM100T is 100 watts with transformer taps of 100, 50, 25, and 12.5. A screw-
driver operated power switch is used to select the desired tap. This unit is designed for
use in 70Vrms distributed systems.
The exterior is finished in durable, weatherproof paint. All openings are gasketed
to provide a watertight enclosure.
Ideal for both indoor and outdoor applications, these drivers are well suited for
any installation requiring rugged, 70 volt, high-power performance.
-1-
Publicidad
