Publicidad
Idiomas disponibles
Idiomas disponibles
Call Alert™ is a per-radio feature. Your radio acts like a pager. When a call alert (page) is
received, four beeps sound and the LED flashes green until the PTT is pressed or SB3 is
pressed and released.
Voice Selective Call radios receive a voice message.... a one-time two-beep tone sounds
and the green LED lights. At the end of the voice message the radio returns to normal
operation.
Repeater Access equipped radios transmit a code one of two ways; automatically prior to
data and voice transmission, or manually by pressing SB2. A sidetone is generated and an
acknowledge alert tone is received.
Quik-Call ll™ Decode Signalling
Quik-Call ll is a per-radio feature enabled on a per-channel basis and offered as individual
call, group call, and dual call.
To activate Quik-Call, turn the radio on and place the ABC switch in the A position (if so
programmed) or rotate the channel selector to the channel programmed for Quik-Call ll.
When a page is received, the green LED flashes and an alert tone is emitted.The radio
resets to the signalling muting state automatically (if programmed for auto reset) or when
the monitor button is pressed.
Touch-Code™ DTMF
A DTMF programmed radio can transmit and receive phone calls through the public tele-
phone system.
•
Calling with Auto Access: Press the phone key, listen for the dial tone, and dial using
the keypad. Press the phone key to hang up.
•
Calling with Manual Dial: Press the phone key to enter the phone mode. Enter any
required access code using the keypad. Enter the deaccess code to hang up.
Repeater Talkaround
Transmit DIRECT (portable-to-portable), bypassing the repeater, or transmit in the
REPEAT mode, through a repeater for increased range. This feature can be programmed to
the ABC switch (DIRECT on one position and REPEAT on another position), or to selected
channels.
Smart PTT
With this feature enabled, your radio:
•
will not transmit on a busy channel, or
•
will not transmit on a busy channel with PL/DPL squelch code other than your own.
Pressing the PTT on a busy channel causes a continuous alert tone until the PTT is
released, (no transmission occurs).
PAC•RT
Radios with PAC•RT communicate through a vehicular repeater to a mobile base station.
To activate PAC•RT, turn the radio on and place the ABC switch in the A position (if so
programmed) or rotate the channel selector to the channel programmed for PAC•RT.
With PAC•RT selected, all messages are communicated portable-to-base. In other posi-
tions of the ABC switch, or on other selected channels, the radio transmits and receives
portable-to-portable.
, Motorola, HT 1000, Channel Scan, Quik-Call II, Touch-Code, Stat-Alert, Call Alert,
© 1997 by Motorola, Inc.
8000 West Sunrise Blvd.
Ft. Lauderdale, FL 33322
and PAC•RT are trademarks of Motorola, Inc.
Printed in U.S.A.
All Rights Reserved
Publicidad
