Craftsman CMXZDCG453 Manual De Instrucciones

For use with CRAFTSMAN ® garage door openers manufactured after January 1, 1993. The garage door opener
activates when the programmed button on the remote control is pressed. The remote control can activate up to
three garage door openers.
Make sure the garage door opener has a working light bulb because it is a programming indicator.
MODEL CMXZDCG453
LED
WARNING: This product can expose you to chemicals including lead, which are known to the State
of California to cause cancer or birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
PREPARE
PROGRAM THE REMOTE CONTROL
1
Press and hold the program button
by using the visor clip until the LED
on the front of the remote control turns
on.
4
Press and release the Learn
button on the garage door
opener.
Learn
Button
The Learn LED will light.
Within 30 seconds...
®
Learn
OR
LED
Green
or
Learn
LED
Red/Orange
Purple
2
Press and release the remote control button you wish to use the
number of times that corresponds with the garage door opener type:
# of Presses
1
2
3
4
5
Press the remote control button
programmed in step 2 until the
garage door opener lights flash
or two clicks are heard.
Locate the Learn
button on the garage
door opener.
NOTE: Your garage door
opener may look different.
OR
Learn
LED
Yellow
Garage Door Opener Type
Security+ 2.0 ® (Yellow Learn Button)
®
Security+ (Purple Learn Button)
®
Security+ (Red/Orange Learn Button)
Billion Code (Green Learn Button)
6
To test, press the programmed
button on the remote control...
3-BUTTON REMOTE CONTROL
MODEL CMXZDCG453
To prevent possible SERIOUS INJURY or DEATH from
a moving gate or garage door:
• ALWAYS keep remote controls out of reach of
children. NEVER permit children to operate or
play with remote controls.
• Activate gate or door ONLY when it can be seen
clearly, is properly adjusted and there are no
obstructions to door travel.
• ALWAYS keep gate or garage door in sight until
completely closed. NEVER permit anyone to
cross path of moving gate or door.
Locate the Program button on the
remote control.
3
Now, press any remote-control
button except the button that
was selected in Step 2.
7
Install the visor clip.
The garage door
opener will activate.
Program Button