Publicidad
Idiomas disponibles
Idiomas disponibles
BATTERY
If the battery is low and needs replacement, the LED on this remote will not illuminate when the buttons are
pressed. To replace battery, open the case as shown. Insert battery positive side up (+). Replace the battery
with only 3V CR2032 coin cell batteries. Dispose of old battery properly.
Pry open the case first in the middle (1), then at
each side (2 and 3) with the visor clip.
2
REPLACEMENT PARTS
Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .K010A0020
Visor Clip . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . K029B0137
1
3
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify
doctor.
To reduce risk of fire, explosion or chemical burn:
• Replace ONLY with 3V CR2032 coin batteries.
• DO NOT recharge, disassemble, heat above
212° F (100° C) or incinerate.
NOTICE: To comply with FCC and or Industry Canada rules (IC),
adjustment or modifications of this receiver and/or transmitter are
prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards for Home or office use. Operation
is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
To order replacement parts call...
1-888-331-4569
www.craftsman.com
Publicidad
