Medisana RS 700 Manual De Instrucciones página 14

3.2 Power on the device
• Plug the mains cable completely into the mains connection on the
device.
• Plug the power plug into a wall outlet.
• Set the on/off switch to the „l" position.
If the electrical connection is interrupted during the mas-
sage, massage heads will return immediately to the
parking position after being reconnected to the power
supply.
3.3 Functions and remote control
After the unit is powered and the On/Off switch is set to position „I", the unit
is in sleep mode.
Only a few basic functions are available in this mode.
• The z and u buttons change the angle of the back section and the leg
section of the device.
• Button 0 switches the unit on completely.
Overview of all remote control buttons
0 On/Off button: Press the button once: The button lights up and device is
ready.
Now select one of the massage function buttons to start the massage.
Press button 0 again to end all massage functions. The moving parts of
the massage chair will then return to their original position.
see postion
5
q Demo: Press the Demo button once to run an automatic demonstration
of all massage functions. The automatic program combines all
types of massage (kneading, tapping, Swedish massage, shiatsu, rolling
massage). The demonstration lasts 15 minutes and will be stoped auto-
matically. Press the demo button again at any time to manually stop the
program.
w Manual (manual selection of massage functions)
Circle through six functions of the button: Kneading, Taping, Swedish mas-
sage, Shiatsu, Rolling massage, Stop massage function.
e Vibration: Press the button to activate/deactivate the vibration function.
Select the intensity of the vibration with the button r .
r Intensity: Press the button to adjust the intensity of the vibration
in several steps.
t Point/Partial
Press the button once to preform spot massage at the current point on the
back.
Press the button again to switch to partial back massage -
The massage heads move up and down 8 cm at the selected point.
Press the button again to stop the function and return to full massage
mode.
z u Back and leg section adjustment: the buttons change the angle of
the back section and leg section of the device. Press the respective button
once to start the movement, press the button again to stop the movement.
Recline ( z ): the chair moves towards reclining postion.
Upright ( u ): the chair moves towards upright position.
GB
3 Operating
6