Switching Off The Device; Troubleshooting - Medisana RS 700 Manual De Instrucciones

3.5 Switching off the device

Press the Power button 0 on the remote control.
All functions are terminated - but the massage heads are still moving to
their parking position. Please wait a few seconds.
Then set the on/off switch (position 5 ) to position „O" and disconnect the
device from the power socket.

3.6 Troubleshooting

problem possible cause
The device does not The device is not plug-
work ged in properly
The device stopped The device has just
working finished its auto timer
session and has auto-
matically switched to
standby mode.
The device stopped You may have used
working the device continuous-
ly for 30 minutes
where the over-heat
protection has been
activated.
The device stopped An excessive load has
working been applied on the
device.
The device is abnor- The device is likely to
mally warm be overused.
Noise can be heard Noise is made by the
from the device mechanical parts of
the device.
If the problem encountered is not listed, please try the following suggestions:
1. Turn off the product and unplug it.
2. Wait for 30 minutes.
3. Plug the product back to the recommended outlet and restart.
4. If the problem persists, contact the authorized service center.
The service centre address is shown on the attached leaflet.
3 Operating GB
suggestion
Ensure the voltage
on the device corre-
sponds to the local
mains voltage and
then plug in again.
Make sure the outlet is
properly working.
If you want another
session, press the
power button again.
Unplug the device and
let it cool down for 30
minutes before you
use it again.
Reduce the excessive
load and start again.
Unplug the device and
let it cool down before
using it again.
This is normal and
does not mean that
the device is faulty.
7