MADISON MAD-CENTER130CD-BK Manual Del Usuario página 6

Auto standby
When playing media from a connected device, the tower automatically switches to
standby if :
-
No button is pressed for 10 minutes,
-
No audio input from a connected device for 10 minutes.
Setting the Clock
After the unit is plugged into a mains supply or mains power failure, the display will
show the "0:00" on the LED display. The unit should be in standby mode to set the
current clock.
1. Press TIME/ALARM button, the digits for the display will blink.
2. Press the
TIME/ALARM to confirm the hour setting
3. The minute digits on the display will blink.
4. Press the
TIME/ALARM to confirm the minute setting.
Setting Alarm
This unit can be used as an alarm clock, CD /USB/SD/ FM is activated to play at a
preset time.
1. Press to switch the unit to standby mode
2. Make sure that you have set the clock correctly
3. Press and hold TIME/ALARM button in shutdown state, the display will flash
ON to select setting alarm and the display will blink.
4. Press the TIME/ALARM confirm, the time display will blink
5. Press /
6. Press /
7. Press TIME/ALARM to confirm, and then press
CD/USB/SD/FM status. Press TIME/ALARM to confirm.
8. The volume would turn up from 0 to 20 gradually.
9. Press TIME/ALARM button in shutdown state, the display will flash ON to
select setting alarm, and the display will blink.
10. Press the
©Copyright LOTRONIC 2018
/ button repeatedly until correct hour is set. Press the
/ button repeatedly until correct minute is set. Press the
button repeatedly to set hour. Press TIME/ALARM to confirm
to set minute.
/ to select OFF to cancel alarm.
/
6
to select
MAD-CENTER130CD