Changing The Combination Of The Transmitter And The Receiver - Kenwood SLG-7 Manual De Instrucciones

Changing the Combination of the Transmitter and the Receiver

To use the Transmitter with a different Receiver or to use the Receiver with a different
Transmitter, it is necessary to coordinate their IDs as described below. Note that the
following operation is not required when using the Transmitter and the Receiver supplied
together in the same package because their IDs have already been coordinated at the
factory.
1
Place the Transmitter and the Receiver within a close distance (about
30 cm) in which you can operate both of them simultaneously.
2
Switch the Transmitter and the Receiver ON.
3
Press and hold the channel selector keys on the Transmitter and
Receiver simultaneously.
The RF lamp on the Transmitter flashes.
The RF lamp on the Receiver flashes.
4
When the RF lamps on both the Transmitter and the Receiver stop
flashing and start to light steadily, release the channel selector keys.
Transmitter
Receiver
19
English