SATA 97925 Manual Del Uso página 16

7.1 Properly installed accessories （optional parts）:
Image
Warning:
Make sure the tool is closed and the nozzle is cooled down
Articles may be ignited if the used accessories are fallen. Accessories must be installed firmly on the machine
Contact with a hot nozzle may cause severe burn. Install or replace accessories after the machine is completely cooled down,
or use suitable tools to install or replace accessories
Hot nozzles may ignite the base. The uncooled nozzle can only be placed on a heat-resistant base
The use of wrong or faulty accessories may cause hot air to flow back and damage the machine. Only machine-specific
original accessories in the table can be used
8. Instructions:
1 ） Always comply with safety instructions and applicable regulations.
2 ） When using the tool with one hand, do not place the other hand in the vent before operation.
3 ） Install the correct fittings for the applied target.
4 ） Set the required air temperature.
8.1 Start and close:
1 ） Push the switch to I/II to start the hot air gun. At the beginning of start, there will be a small amount of smoke from the hot air gun,
this is normal.
2 ） Adjust the temperature to the minimum for cooling, and then push the switch to 0 to close the hot air gun. Cool down the hot air
gun before moving or storage.
8.2 Settings of temperature and air volume:
16
97925
Description
Economical spade nozzle
Economical reflecting nozzle
Economical circular nozzle
Economical wide nozzle
Economical scraper
中文
EN DE RU KO
Application
Protect glass when removing the
membrane paper from window
frames
Soldering pipe
Welding, shrink film （small range of
heating）
Dry or melt （a relatively wide range
of heating）
Scratch off the paint to make the
surface bright
PT JA ES