Publicidad
Idiomas disponibles
Idiomas disponibles
FLUSH MOUNT
OCCUPANCY DETECTOR
INTRODUCTION
e3 is a 360 degree flush mount occupancy
detector that uses a passive infrared sensor
to detect changes in temperature emitted by
persons or objects passing through its
detecting area.
The sensor will keep the connected lighting
fixture on even when you are seated and can
detect very slight movements (a seated
person's head or hand movements).
e3 can support "master/slave" connections
for large area coverage requirements.
Note: Read this entire manual before you
start to install the system.
PRODUCT OVERVIEW
Lens
Main Body
Protection Case
Spring Clip (x2)
SAFETY PRECAUTIONS
Avoid installing the unit in storming or
raining weather.
Be sure to isolate or switch off power
source before installing or maintenance.
DO ensure that the power supply circuit is
protected by a 16 amp circuit breaker or
suitable equivalent fuse.
e
3
11
IMPORTANT
Installation must be performed by skilled technicians
who are informed about the standards and technical
requirements of the appliance and its proper
installation.
Check your local codes as they apply to your
situation.
If the house wiring is of aluminum,
consult with an electrician about proper wiring
methods.
Before proceeding with the installation, TURN OFF
THE POWER TO THE LIGHTING CIRCUIT AT
THE CIRCUIT BREAKER OR FUSE BOX TO
AVOID ELECTRICAL SHOCK.
CHOOSING A MOUNTING LOCATION
When deciding a proper location to install the
unit, please take the following points into
consideration:
The unit is designed for indoor ceiling
flush mount and is not suitable for wall
mount. (FIGURE 1)
FIGURE 1
Avoid aiming the occupancy detector at
pools, heating vents, air conditioners or
objects which may change temperature
rapidly.
Do not allow sunlight to fall directly on the
front of the unit.
The occupancy detector is more sensitive
to an object moving across its field of view.
It is less sensitive to an object moving
directly
towards
(FIGURE 2)
FIGURE 2
The unit has a sensing angle of 360° and
can detect up to 3 meters radius for micro
the
sensor
head.
Publicidad
