Device Configuration; Esi[Tronic] Software Update With Kts 520/550 - Bosch KTS 520 Instrucciones Manejo

KTS 520 / 550
...4. Start up
4. 1 Device configuration
Before you can use the KTS 520/550 to perform
a control-module diagnosis or a multimeter
measurement, you must first configure the de-
connected by a COM interface.
vice when it is
Configuration is not necessary if the device is
connected using the USB interface.
On your PC go to the Windows start menu and
clock on"Settings". When there select Controls
„
and open the
gram.In this program you must configure your
device using "SD Hardware" to KTS 520 or
KTS 550 . In addition you must also configure
the correct COM interface (ex-factory confi-
guration: COM 1). The device configuration
is concluded by "accepting" the settings and
closing the program.
i
If in WIN XP in the control panel th
system"
application program cannot be
found, then you have to activate the „Classic
view" in the control panel.
Robert Bosch GmbH
RBsystem"
application pro-
„ RB-
4.2 ESI[tronic] software update with KTS
520/550
!
When updating the software, the serial con-
necting cable in the delivery specification must
be used.
ESI[tronic]
On an
ware of the KTS 520/550 is usually also up-
dated.
When performing a software update we re-
commend that you connect the KTS 520/550
to the PC test system and attach it to the power
pack included.
ESI[tronic]
Ifan softwareupdatehasbeencarried
out without the KTS 520/550,when starting con-
trol unit diagnosis you are prompted to update
the diagnostic tester firmware. To do so, click on
the Windows Start button and choose „Settings"
- „Control Panel" -
„Firmware"
tab and choose
start updating the KTS 520/550 firmware.
EN 15
software update the firm-
„ RBsystem"
. Select the
„Start Update"
to
1 689 979 857 (2004-11-16)