Replacing The Bulbs - Home Decorators Collection Brivana MTVS2528W Guía De Uso Y Cuidado

Maintenance
1
removing the access panels
NOTE: this fireplace insert uses two clear 120 volt, 40 Watt,
e-12 socket base light bulbs (small base, chandelier candle
type bulbs) . the light bulbs are located at the bottom of the
unit . You can change the light bulbs from the back of the
firebox . For convenience, if one of the light bulb burns out, it
may be easier to replace all of the light bulbs at the
same time .
□ turn the firebox master power "on/off" switch to the "off"
position, (located behind the front access panel) .
□ Pull the mantel away from the wall, as you need to access
the back of the firebox . Unplug the firebox from the power
outlet .
□ let the firebox insert cool if it has been operating .
□ looking at the back of the firebox, locate the access panel .
□ remove the screws in each panel using a Phillips or
flathead screwdriver .
access panel
2

replacing the bulbs

WARNING: do not exceed 40 Watts per bulb . Use of
higher rated light bulbs may cause overheating and result
in a fire, causing property damage, personal injury, or loss
of life .
□ Carefully remove the burnt light bulb . this may require
holding the light socket with one hand while unscrewing
the light bulb with the other hand .
□ install the new light bulbs .
□ Push in the slides and replace the access panel .
□ insert and tighten the screws in the panel that were
removed .
□ Plug the firebox into the power outlet and return your
mantel to its original position against the wall .
□ turn the firebox master power "on/off" switch to the "on"
position and press the power button (1) on the control
panel (P) . Check that the replacement bulbs are working .
13
Please contact 1-800-986-3460 for further assistance
HOMEDEPOT.COM/HOMEDECORATORS