Zodiac Ei2 Expert Manual De Instalación Y De Uso página 24

2.5.2 Connecti on to an electric roller shutt er
If the pool is fi tt ed with an electric roller shutt er, it can be connected to the chlorinator using a dry contact so that
the latt er automati cally adapts its chlorine producti on when the shutt er is closed (see "3.2.3 "LOW" mode: chlorine
producti on reduced to 10 % if the pool is covered").
•
Make sure the appliance is powered off .
•
Remove the 12 screws securing the cover and remove it (take care not to disconnect the ribbon cables).
•
Unscrew the dedicated cable gland ti ghtening ring (at the bott om of the control box) and remove the plug to feed
through the cable from the shutt er. Tighten the cable gland ti ghtening ring.
•
Connect the cable from the shutt er to the "POOL+" and "POOL-" connectors on the printed circuit board.
•
Close the box according to the ti ghtening order shown on the following diagram (9 long screws for the perimeter of
the box and 3 short screws for the bott om of the box). The protecti on rati ng of the box for water ingress (IPX5) may be
aff ected if this procedure is not strictly observed.
A
B
C
D
Shutt er connecti on (contact closed = shutt er closed)
E
F
G
H
I
• The chlorinator is compati ble with several diff erent types of electric shutt er. However, certain systems may not
be compati ble. In this case, acti vate "Low" mode manually from the chlorinator control panel (Ei² Expert only).
• Refer to the shutt er manufacturer's installati on manual.
• The dry contact operati ng principle is as follows: contact closed = shutt er closed.
8
Connecti ons
H
I
Mains power supply 220-240 Vac / 50 Hz
Cell power supply
Memory batt ery type CR2032
Connecti on of fl ow switch
LCD connecti on ribbon cable
Keypad connecti on ribbon cable
Transformer connecti ons
Fuse 2.5 A ti me-delayed
F G
Torque = 1.2 N.m (= 12.2 kg.cm)
Ei²
GenSalt OE
X
X
X
X
X
X
X
Ei² Expert
X
X
X
X
X
X
X
X
X