Water Filtration System - KENMORE ELITE 106.5171 Serie Manual De Uso Y Cuidado

To Dispense Ice:
1. Make sure the desired type of ice is selected. To switch
between cubed and crushed, press WATER/ICE.
WARNING
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
2. Press a sturdy glass against the dispenser pad. Hold the
glass close to the ice guide to ensure that the ice dispenses
into the glass.
A. Ice guide
IMPORTANT: You do not need to apply a lot of pressure to
the pad in order to activate the ice dispenser. Pressing hard
will not make the ice dispense faster or in greater quantities.
NOTE: To dispense both water and ice at the same time,
press the DISPENSE WATER button while using the dispenser
pad to dispense ice.
3. Remove the glass to stop dispensing.
NOTE: Ice may continue to dispense for several seconds
after removing the glass from the pad. The dispenser may
continue to make noise for a few seconds after dispensing.
The Dispenser Light
The dispenser has two separate lights: a white dispenser light
and a blue dispenser pad light.
The white dispenser light automatically turns on when you use
the dispenser, then turns off when dispensing stops.
The blue dispenser pad light can be manually turned on or off.
Press the ACCENT LIGHT button to turn the dispenser
pad light on. The display screen indicates when the light
is on.
Press ACCENT LIGHT a second time to turn the dispenser
pad light off.
12
The dispenser lights are LEDs that cannot be changed. If it
appears that your dispenser lights are not working, see "Problem
Solver" for more information.
The Dispenser Lock
The dispenser can be turned off for easy cleaning or to avoid
unintentional dispensing by small children and pets.
NOTE: The lock feature does not shut off power to the
refrigerator, to the ice maker, or to the dispenser light. It simply
deactivates the controls and dispenser pad. To turn off the ice
maker, see "Ice Maker and Storage Bin."
Press and hold LOCK for 3 seconds to lock the dispenser.
Press and hold LOCK a second time to unlock the dispenser.
The display screen indicates when the dispenser is locked.
A
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Water Filter Status Light
The water filter status light will help you know when to change
your water filter.
When the dispenser control panel's water filter status
display changes to "ORDER," this tells you that it is almost
time to change the water filter cartridge.
Replace the water filter cartridge when the water filter
status display changes to "REPLACE."
NOTE: If water flow to your water dispenser or ice maker
decreases noticeably, change the filter sooner. The filter
should be replaced at least every 6 months, depending on
your water quality and usage.
You can check the remaining life of your water filter at any time.
Press SETTINGS, then press SETTINGS again. The display
screen will show how many more gallons of water the filter
can effectively filter. Press WATER/ICE to exit the filter
status screen.
NOTE: A new filter's "Gallons Remaining" display is 200.
The "ORDER" status begins at 40 gal. (151 L) remaining, and
the "REPLACE" status activates when the filter has 0 gal.
remaining.

Water Filtration System