3. INSTRUCTIONS FOR OP-
ERATION
Unpack the compressor and check for any defi-
ciency, damage caused during transportation
and loose bolts and screws.
WARNING
READ SECTION TITLED " SAFETY INSTRUC-
TIONS "
WEAR SAFETY GLASSES OR GOGGLES
Danger to the eyes always exists due to the pos-
sibility of dust being blown up by the exhausted
air or of a fastener flying up to the improper han-
dling of the tool. For these reasons, safety glass-
es or goggles shall always be worn when
operating the tool.
The employer and/or user must ensure that
proper eye protection is worn. Eye protection
equipment must conform to the requirements of
Council Directive 89/686/EEC of 21 DEC. 1989
(the American National Standards Institute.
ANSI Z87.1) and provide both frontal and side
protection.
NOTE: Non-side shielded spectacles and face
shields alone do not provide adequate
protection.
NOTE: The information contained in this Instruc-
tion Manual is designed to assist you in
the safe operation and maintenance of
the compressor.
Some illustrations in this Instruction
Manual may show details or attach-
ments that differ from those on your own
compressor.
1. INSTALLATION
Thinner
Gasoline
WARNING
1. NEVER USE THE MACHINE IN A PLACE
WHERE ANY VOLATILE COMBUSTIBLE
SUBSTANCE HAS BEEN STORED.
Never use it near gasoline, thinner, gas,
paint or adhesive agent, because they could
be ignited or blow up.
WARNING
2. NEVER USE THE MACHINE NEAR THE
HEAT OF FIRE OR ANY COMBUSTIBLE
SUBSTANCE.
WARNING
3. NEVER USE THE MACHINE IN AN UN-
STABLE PLACE.
Never use it in a place where it could move
or fall of itself.
Be sure to install the compressor on a flat
floor, with leg rubber underneath it; the al-
lowable tilt angle of the floor is up to 10 de-
grees. If the installation floor is tilted and
slippery, ensure that the compressor does
not move during operation. Do not use it on
a shelf or a stand where it may fall or tumble.
10