Safety Precautions; Before First Use; Preparation Of Ice-Cream - Krups Gelatissima 358 Instrucciones De Uso

English

Safety Precautions

Read these instructions carefully before
using the appliance.
The voltage stated on the rating plate
must correspond with that of the mains
supply.
Do not place the appliance on hot
surfaces, such as a stove hot plate, or use
or leave it in the vicinity of a naked gas
flame.
Keep the appliance away from children
and do not allow the mains flex to hang
down.
Never dip the motor unit into water.
Do not heat the freezing container above
40 °C. Do not put it into a dishwasher,
oven or microwave and do not fill it with
hot liquids.
The mains plug must be pulled out if
anything untoward occurs during
operation and also before every time the
lid is removed.
Never reach into the filling opening either
with your fingers or with any utensil.
Disconnect the appliance from the power
supply after using and always before any
cleaning operation.
Do not allow the flex to hang over
corners or edges.
Do not remove the mains plug by pulling
on the flex.
Do not operate the appliance if the mains
flex or the appliance itself is in any way
damaged.
If the mains flex of this appliance does
become damaged, it must be repaired
only by the KRUPS Customer Service
Department or by a similarly qualified
individual, in order to avoid danger to the
person.
10

Before first use

Before using the appliance for the first time,
the appliance should be taken apart and
cleaned, in order to remove any possible
residues from the manufacturing process.
Press the release key at the rear of the
motor unit and lift out the lid obliquely
upwards complete with the motor (1).
Push the motor towards the rear out of
the lid (2).
Clean the freezing container, lid and stirring
paddle in lukewarm water with washing-up
liquid.
Never dip the motor unit into water but just
wipe it with a moist cloth.
Dry all parts carefully.

Preparation of Ice-cream

Freeze the empty freezing container for at
least 24 hours at -18 °C, making sure that
the container is completely dry both inside
and outside and that the opening is not
covered.
Prepare the ice-cream mixture (see recipes).
Warm mixtures should be pre-cooled in the
refrigerator.
Due to the volume increase during
preparation, the quantity of ice-cream
mixture must not exceed 1 kg for sorbets or
1 litre for milk-based ices. Take this into
account when using your own recipes.
First assemble the motor and lid. Then have
the prepared and pre-cooled ice-cream
mixture ready to hand before taking the
freezing container out of the freezer.
Push the motor unit onto the lid until it
engages properly (3).
Remove the freezing container from the
freezer.
Insert the stirring paddle into the
container (4).
Place the lid onto the freezing container
with the projections properly located at
the edge. Then secure the lid at the rear
with a click onto the container (5).