Unpacking Instructions - Fanimation Enigma FP2120 Serie Manual Del Propietário

This manual is designed to make it as easy as possible for you
to assemble, install, operate, and maintain your ceiling fan
Tools Needed for Assembly
•
One Phillips head screwdriver
•
One stepladder
•
One ¼" blade screwdriver
▲WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 5). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in finding your place should you be interrupted.
▲WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
Check to see that you have received the following parts:
• Ceiling Fan assembly
• Downrod/Hanger Ball assembly
• Ceiling Canopy
• Hanger Bracket
• Motor Coupling Cover
Hanger
Bracket
Motor Coupling
Cover
Lower Cap
NOTE: The illustration shown is not to scale or its actual configuration may vary.
Wires partially removed for clarity.
•
9 " Socket head wrench
16
•
One wire stripper

Unpacking Instructions

Ceiling Canopy
Downrod/
Hanger Ball
Assembly
Wiring outlet box and box connectors must be of type re-
quired by local code. The minimum wire would be a 3-con-
ductor (2-wire with ground) of the following size:
Installed Wire Length
Up to 50 ft.
50 - 100 ft.
NOTE: Place the parts from the loose parts bags in a
small container to keep them from being lost. If any parts
are missing, contact your local retailer.
• Hardware bag:
– Four wire connectors
– Two 5 / " threaded rods
32
5
– Two / " lockwashers
32
– Two 5 / " knurled knobs
32
• Support Cable bag:
– Ceiling Support Cable
– Cable Clamp
– " x 2" lag bolt
– " flat washer
• Lower Cover Assembly
• Lower Cap
• Hand-held Remote
• Receiver Unit
• LED Bulb
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 1, page 13)
Lower Cover
Assembly
LED Bulb
3
Materials
Wire Size A.W.G.
14
12
Hand-held
Remote
Hardware Bag
Ceiling Fan
Receiver
Unit
Assembly