How To Wire Your Ceiling Fan; Operating Instructions - Tr24Wh Hand-Held Remote - Fanimation Enigma FP2120 Serie Manual Del Propietário

If you feel that you do not have enough electrical wiring
knowledge or experience, have your fan installed by a
licensed electrician.
▲WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
1. Setting the Code: The remote unit has 16 different
code combinations. To prevent possible interference from
or to other remote units such as garage door openers, car
alarm or security systems, simply change the combination
code in your transmitter and receiver. To set the code,
perform these steps.
Transmitter: remove battery cover. Press firmly below
arrow and slide battery cover off. Slide code switches to
your choice of up or down position. Factory setting is all
up. Do not use this position. With a small screwdriver or
ball point pen slide firmly up or down (Figure 1a). Replace
battery cover on the transmitter.
Receiver: Slide code switches to the same positions
as set on your transmitter (Figure 1b).
Remote
Transmitter
Unit Detail
ON ESE
1 2 3 4
Figure 1a

Operating Instructions - TR24WH Hand-held Remote

▲WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades is in place. Noise and fan damage
could result.
1. Operating & Using Hand-held Remote (Figure 1):
Install two piece of 3 volt battery (If not using for long
periods of time, remove battery to prevent damage to
hand-held remote). Store the hand-held remote away from
excess heat or humidity.
• HI Push Button – high fan speed
• MED Push Button – medium fan speed
• LOW Push Button – low fan speed
• OFF Push Button – fan off
• Light Push Button – no function (unless light bulb is
installed)

How to Wire Your Ceiling Fan

Receiver
Unit Detail
Figure 1b
9
NOTE: If fan or supply wires are different colors than indicated,
have this unit installed by a quali ed electrician.
GRN or BARE GROUND
WH-TO MOTOR N
BLK-TO MOTOR L
BLUE-FOR LIGHT DOWN
2. Installing Receiver in Hanger Bracket:
• Slide remote Receiver into the Hanger Bracket
(Figure 2).
• Connect wires as indicated: (Figure 3)
– Green Hanger Bracket and Hanger Ball wires to
BARE (ground) wire.
– BLACK Receiver Unit wire (AC IN L) to BLACK
supply wire.
– WHITE Receiver Unit wire (AC IN N). to WHITE
supply wire.
– WHITE Receiver Unit wire (TO MOTOR N) to WHITE
fan wire.
– BLACK Receiver Unit wire (TO MOTOR L) to BLACK
fan wire.
– BLUE Receiver Unit wire (FOR LIGHT DOWN) to
BLUE light wire.
• Position all connected wires and receiver antenna to
allow installation of ceiling canopy.
• To install ceiling canopy, see page 10.
• Restore electrical power.
3V, CR2032
BATTERY
2 PCS
Ceiling
Bracket
(Open End)
Receiver Unit
NOTE: Receiver wires omitted for clarity.
Figure 2
WH-AC IN N
BL-AC IN L
120 VAC SUPPLY
(User Supplied)
BLK-ANT
Figure 3
Figure 1