Cross Referencing The Colors For The Wires - Marklin Digital 60973 Manual Del Usuario

B/GR = Märklin connection to the pickup shoe (red) / DCC
track right rail
v = front connection
LR = rear light(s) (yellow)
+Ub = light(s) ground wire (orange)
LV = front light(s) (gray)
+Ub = light(s) ground wire (orange))
AUX 1 = physical output (brown/red)
AUX 2 = physical output (brown/green)
MR = Motor Output 1 (blue)
MV = Motor Output 2 (green)
= Speaker connections
CLK = not available at present
DAT = not available at present
IN1 = not available at present
IN2 = not available at present
IN3 = not available at present
GND = Electronics ground (violet)
+5V = (pink)
After finishing the wiring, mount the circuit board with the
pad included for this purpose. Make sure that the circuit
board cannot cause a short circuit.
Before you plug the decoder in, it must be programmed
correctly.
Outputs 3 (forwards) and 4 (reverse) must be active for
the pickup shoe changeover. The setting for this is done in
mDT3 be means of the function activator „ALWAYS" and
„Action to ALWAYS". The programming here depends on the
wiring, and it may be necessary to swap the outputs in the
functions.

Cross Referencing the Colors for the Wires

Description
Motor Connection 2
Conductor Current Pickup, Track, Left
(DC) Outer (AC)
Front Lights
Aux 1 (physical output)
Common Wire for Lights /Aux 1-2
Rear Lights
Conductor Current Pickup,
Track, Right (DC) Center (AC)
Motor Connection 1
Aux 2 (physical output)
GND Electronics ground
+5V
Wire Color
NEM Märklin
gray blue
black brown
white gray
green brown/red
blue orange
yellow yellow
red red
orange green
violet brown/green
violett
pink
7