Publicidad
Installing the motor
Match the three holes at both ends of the hanger bracket (A)
and the mounting bar (I). Secure the fan assembly (B) onto
the hanger bracket (A) with the three mounting screws and
washers (SS) as removed in step 2 (Hanging the fan to the
hanger bracket).
Attaching the motor housing
Place the motor housing (C) over the motor assembly (B) and
against the ceiling, matching the four holes on the perimeter
of the hanger bracket (A). Secure the housing (C) onto the
hanger bracket (A) with the four side-mount screws (JJ) and
washers provided.
Insert the blade screws (AA) through the blade (D) into the
blade holder (E). Do not tighten any of the screws (AA) until
all three screws have been started into the blade holders (E).
Once all three screws (AA) are attached, tighten each screw
(AA) securely starting with the center screw. Make sure the
blade (D) is straight.
Repeat these steps for the remaining blades (D) and blade
holders (E).
SS
A
C
AA
E
1-855-HD-HAMPTON
A
SS
B
JJ
B
D
Publicidad
