SATA 98107 Manual Del Uso página 16

2. Unit conversion table:
1. Press " " once, the [Function setting] icon lights up, and the current unit flashes.
2. Press "-" or "+" to select the desired unit which will be automatically saved after 3 seconds.
Description: The original unit is Bar, and three other units are available: Psi / KPa / Kg / cm
3. Inflation pressure setting:
1. Press the shortcut key "
2. Press +/- to adjust the target pressure value.
3. Press " " to confirm
4. The target pressure value is saved to the shortcut key.
5. For " " and " ", the pressure value can be set in the same way.
4. [OPS]/[New Tire Over-inflation] function:
1. Press " " twice, and the [New Tire Over-inflation] icon flashes on the display.
2. Press "-" or "+" to select the desired over-inflation value which will be automatically saved after 3 seconds.
3. After the over-inflation value is set correctly, the [New Tire Over-inflation] icon will be shown on the display.
4. Press and hold " " until the air comes from the inflation chuck, and connect the chuck to the valve core.
5. When the buzzer beeps, the inflation is completed. Pull off the inflating valve chuck.
6. Turn off the over-inflation function, and set the over-inflation value to 0.
Special notes:
[OPS]/[New Tire Over-inflation] is an over-inflation function for the new tire inflated for the first time so as to make the tire fit tightly with
the wheel hub.
The over-inflation value is equal to the maximum tire pressure (MAX.PRESSURE) minus the standard tire pressure. For example, for a new
tire with a MAX. PRESSURE of 350KPa (51Psi), the maximum tire pressure is 3.5Bar. So if the standard tire pressure is 2.5Bar, the over-
inflation value shall be set to 3.5-2.5=1Bar.
*1Bar=100KPa; 1Psi=6.89KPa; 1Bar=1.02 Kg/cm
5. Strong inflation function:
1. Set the inflation target pressure value as needed.
2. Press and hold " " until the air comes from the inflation chuck, and connect the chuck to the valve core.
Note: When the equipment detects a tire pressure lower than 0.2Bar, it is considered to be not connected to the tire by default, and the
automatic inflation function will not be activated.
The strong inflation function helps to solve the problem that the tire does not fit tightly with the wheel hub after the tire has been replaced,
and that the tire pressure is lower than 0.2Bar.
6. LED function:
Press " " three times, and the display shows LON; press +/- button to turn on or off the lighting function
Displaying LON means the LED is on; displaying LOFF means the LED is off.
When the equipment is turned on, the default setting is that the LED lights up automatically.
7. Hose retraction:
Pulling:
1. Slowly pull the hose to the required length, and then lock it with a ratchet brake valve. If it cannot be effectively locked, please continue
pulling it slowly by 6-40cm for locking. Note: Neither pull with a force beyond 1.5-4kg nor exceed the hose limit warning line.
Retraction:
1. First, slowly pull it out by 6-40cm to unlock the ratchet brake valve.
2. Then hold the hose by hand to slowly retract it by spring recovery force.
16
98107
" once to display the current preset pressure value of the shortcut key.
2
EN DE RU KO
2
.
PT JA ES