Faucet Installation - Pfister ASHFIELD LG531 Serie Manual Del Usuario

Thank you for purchasing this Pfister product. All Pfister products are carefully engineered, and factory tested to provide long
trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow illustrated
instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
PRELIMINARY STEPS
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3
3 TOOLS RECOMMENDED
• Plumber's putty • Philips head screwdriver
• Adjustable wrench • Flashlight
Your installation may require new supply lines and/or shut-off valves or other additional
tools.
4
4A
4B
4 VALVE BODY PREPARATION
First, remove Clip (4A) then remove Inlet Connector (4B) from Valve Bodies (4C) and
save. Next, remove Locknut (4D), and Square Washer (4E) from Valve Bodies (4C)
and save.
ENGLISH
• Pliers
• Cloth
4C
4E
4D
2
5
5A
5C
5B
5 HANDLE BODY ATTACHMENT
Slide the Handle Connectors (5A) onto the Spout Bridge (5B). Push the Handle
Connectors (5A) all the way until completely seated. Be careful not to damage O-Rings
(5C). Be sure that the Buttons (5D) are facing the rear, as shown.

FAUCET INSTALLATION

6
6A
6B
6B
1
1 / " [32 mm] MIN.
4
1
1 / " [38 mm] MAX.
2
DIA. HOLES
3 PLACES
6 INSTALLING PUTTY RINGS
Following manufacturer's recommendations on use, place a bead of plumber's putty
in the bottom groove along the outer edge of Putty Rings (6A). Place Putty Rings (6A)
over sink holes (6B).
5D
LEFT
RIGHT
5B
5B
5A
6A
6A
6B