Shop-Vac 405 Serie Manual Del Usuario página 5

handle assembly
1. Attach upper and lower handle sections
and secure at point (A) with ¼ - 20 x
1¼" carriage bolt and ¼ - 20 acorn nut
(Figure 2(A)).
2. Place handle assembly into the motor
carriage unit and secure with ¼ - 20 x
2" Hex Head machine screw, ¼ external
tooth lockwasher and ¼ - 20 Hex nut
(Figure 2(B)). Make sure hex nut is
located on left side of handle when facing
back of the unit or the stand will not work
properly.
3. Secure the cable to the tube using the ties
provided (Figure 3 and 4 for tie wrap
locations).
COLLECTION BAG ASSEMBLY
1. Install the exhaust gasket into the
discharge port of the vac if not already
installed. Make sure the lip of the exhaust
gasket is facing the outside of the
discharge port.
2. Connect the collection filter bag to the
discharge port of the vac (Figure 5).
Twist slightly until locked into position.
Secure power cord with the supplied wire
ties (C).
3. Secure the end of the collection bag to
the upper handle with the strap connection provided (Figure 6).
HEIGHT ADJUSTMENT
WARNING
From opening. to reduce the risk oF injury From moving parts, unplug beFore
servicing.
The Indoor/Outdoor Vac has a 2-position height adjustment. Adjust the
front wheels by placing the axle in the slot that best suits your cleaning
requirements (Figure 7).
ASSEMBLY (CONT'D.)
–
hazardous moving parts! keep hands and Feet away
Figure 2
(C)
Figure 5
Figure 3
Figure 4
Figure 6
Figure 7
PAGE 5